Log Rack Ground Anchor - 15" | Ground Screws for Soil

Ground Anchors for Freestanding Log Racks This kit helps secure freestanding log racks into the ground, specifically for high-wind or stormy waterside locations. The 15" screws are for tightly-packed earth. For loose sand, use the 30" anchors. It requires requires a small socket set or wrench to tighten cable clamps. 

Installation Instructions

1. Insert the sharp tip of a spiral ring anchor into the soil near the bottom of the rack, under the center cross rail. Place one on each side of the center cross rail on the rack.
2. Twist the anchor by hand so that it spirals into the soil. Use a metal bar or something strong that fits in the top ring of the anchor to turn into the ground. Stop when the spiraled section is completely hidden underground and only the ring on top of the anchor is visible.
3. Run the cable through the ring at the top of the anchor, then pass this same line over and around the center cross rail on the rack.
4. Secure the cable using provided cable clamps. Tighten straps to keep the rack tight to the anchors in the ground.